Linn Gears & Sprocketss

Roller Chain Sprockets
	TYPE A SPROCKETS: Machine cut, single strand, Type A steel sprockets. The complete range from No. 25 through No. 240 are stocked including many sizes with and without induction hardened teeth.
	TYPE B SPROCKETS: Machine cut, single strand, Type B steel sprockets. The complete range from No. 25 through No. 240 are stocked including many sizes with and without induction hardened teeth.
	TYPE C SPROCKETS: Machine cut, single strand, Type C steel sprockets. The complete range from No. 25 through No. 240 available, including many sizes with and without induction hardened teeth.
Finished Bore Roller Chain Sprockets
	Finished Bore Sprockets: Stocked for No. 35 through No. 80 chain, with standard keyway and setscrew. Many sizes stocked with and without induction hardened teeth.
	Stainless Steel Finished Bore Sprockets: Not available from stock anywhere else! We carry a wide variety for No. 25, 35, 40, 50, and 60 chain with 2 setscrews.
	Ready Sprockets: An economical assortment of sprockets and hubs drilled and tapped for simple, convenient assembly with standard and hex head cap screws. Stocked for No. 35 through No. 100 chain, with finished bore hubs to accomodate shaft sizes through 2-3/4 diameter, plus a variety of square, hex, spline, and tapered key bores.
Multiple Strand Roller Chain Products
	Double Strand - Mandrel Bore: Double strand steel sprockets stocked in No. 35 through No. 200 for re-boring. Most driver sizes standard with hardened teeth.
	Triple Strand - Mandrel Bore: Triple stand steel sprockets stocked in No. 35 through No. 200 for re-boring. Most driver sizes standard with hardened teeth.
	Quadruple Strand - Mandrel Bore: Four strand steel sprockets for re-boring are stocked for No. 35 through No. 120 chain. Most driver sizes standard with hardened teeth. You won't find these in stock anywhere else!
	Double Taper-Lock® Sprockets: Double strand steel sprockets bored to accept Taper-Lock® bushings stocked in No. 35 through No. 80. Most driver sizes standard with hardened teeth.
Idlers, Clutches, Couplings and Conveyor Sprockets
	Idler Sprockets: Ball Bearing Idler Sprockets have sealed ball bearing with extended inner race and setscrews for securing to shaft. For No. 35 through No. 160 Chain.
	Drivesaver Overload Clutch: Simple, economical, and adjustable over-load protection for shaft sizes from 1/4" through 3-1/2".
	Chain Couplings and Covers: Finished bore, Stock bore, and Taper Lock® bushed chain couplings through 5" bore in a wide variety of sizes from - No. 40 through No. 120 chain. All components required for a complete coupling are stocked, including chains and covers.
	Hinge Top Conveyor Chain Sprockets: Steel sprockets with or without shroud plates in a wide range of tooth sizes. Several sizes stocked with and without center groove.

Accent Bearings Co. Inc.
367 -G South Rohlwing Road
Addison, Illinois 60101
(630) 916-1930
Fax
(630) 916-7740